Mrs sarah jane evans
Had a new toilet put in a few weeks ago, now I have a vibration in the pipes do you know the problem?

There are no answers to this question

Discuss this question

Mr ronald hayward
Can someone please help. To get my gas central heating to turn the heating on I first have to run off a lot of hot water can you please advise me what might be the cause. Thank you RON

There are no answers to this question

Discuss this question

Mr ronald hayward
Where on a hot water tank should the thermostat be?

See answers to this question

Discuss this question

Mr ERIC CURWEN
How do you use a thermostatic radiator valve?

There are no answers to this question

Discuss this question

MR WISH
I have a baxi 105 HE. At the moment it wont heat up my water. I've tried to reset my boiler but it wont reset. Any ideas please?

There are no answers to this question

Discuss this question

sidney
Do I need to bed a shower tray down on a wood floor? if so with what? Can you use plywood screwed down or marine ply or sand and cement?

There are no answers to this question

Discuss this question

sidney
How do I fit a toilet?

There are no answers to this question

Discuss this question

sidney
How to fit a shower tray?

There are no answers to this question

Discuss this question

toilet
How to stop a toilet from whistling when flushed?

See answers to this question

Discuss this question

Mr khalid hussain
My baxi boiler is not heating up my radiators, I've had the heating on for 1hr and it seems to be taking a long time. Can anyone help?

There are no answers to this question

Discuss this question

peter
Are honeywell zone valves 4043 and 6057 pipe connections the same ? They are both 22mm compression. Will the new 4043 fit the old pipes without changes?.

I know the electrics are different.

There are no answers to this question

Discuss this question

nick
I've got a mains water supply to an existing building which was previously a night club, I'm going to renew the feed from the supply. There are two floors of the night club and four flats above. I thought of having three seperate feeds from the mains, one to each of the floors. If I put say three or four coffin tanks on each of the first two floors to feed the night club WC's and run the third feed straight up to the flats, splitting it into each flat on that floor. Do you think this would be the best option and what sort of pressure would I need at the mains ?

There are no answers to this question

Discuss this question

nick
If I convert a house into 4 flats, does each flat require its own separate mains supply from the street?

See answers to this question

Discuss this question

mr
No hot water up stairs but OK down stairs.

There are no answers to this question

Discuss this question

Mr anthony hailes
What action to take, one month old pump not performing?

See answers to this question

Discuss this question

Mr David Armstrong
I have been asked to install non return valves on the hot and cold supply to a bath mixer tap, because the shower head reaches the basin or toilet. Is this a correct/normal procedure? The system is gravity fed and installing these valves will reduce pressure and will make it difficult to remove air locks/blockages in future. Please could you tell me if there is a regulation or recommendation regarding this? thank you.

See answers to this question

Discuss this question

XHayabusa
I live in an apartment without a kitchen sink haha. Anyway what I was thinking of doing is getting a sink and cabinet from a local hardware store (home depot) I can't really alter any of the existing plumbing so I was wondering if I can run a hose type connection to the bathroom sink (which is very close by) and how I would go about doing it. Thanks.

See answers to this question

Discuss this question

splinters
Ideal boiler. MINI C24 COMBI.

The central heating side keeps filling itself and is constantly leaking through pressure relief valve. What is causing this?

See answers to this question

Discuss this question

Mr sammy headdon
Hello, I have a gas radiator that is warm at the bottom and cool at the top. Does this mean it needs to be bleed? If so is this a messy job, will water come out of the radiator and is it a simply job? Yours truly Sammy.

See answers to this question

Discuss this question

Miss lesley small
Radiators working but no hot water?

See answers to this question

Discuss this question

Miss lesley small
Radiators working, pressure OK, temperature gauge fine but there is a small trickle of hot water then cold. What could be wrong?

There are no answers to this question

Discuss this question

Mr joe morgan
How do I service a gas fire?

See answers to this question

Discuss this question

Mr Kenneth Prosser
I have a hot and cold washing machine, I am going to get a cold water fill only washing machine, how should I seal off the existing hot water pipe?

See answers to this question

Discuss this question

Mr Pat Finn
My bathroom was just done but I have hardly any cold water coming out at all, plenty of hot water and it also takes forever to fill the toilet after flushing?

See answers to this question

Discuss this question

Mr Andrew Gutteridge
What is the minimum fall on a toilet waste pipe run?

See answers to this question

Discuss this question

Mr taz  nabil
As a plumber working on a property with other trades, who should I tell when turning of the water mains?

There are no answers to this question

Discuss this question

Mr Gerald Green
How do you install piping for a gas fireplace?

See answers to this question

Discuss this question

Ms vicki hood
What to do for poor water pressure in toilet and cold water in kitchen. Have magnet switch for garbage disposal. Asked plumber to fix. He claims poor pressure on the gizmo below sink for gd. Said I'm into a can of worms. Same plumber refused to change valve behind toilet with low pressure. Kohler insides changed twice. no improvement. advice????

There are no answers to this question

Discuss this question

Ms Linda Grammatico
My kitchen faucet drips. Plumbers have worked on it, new faucets have replaced old ones, and yet the problem persists. What could be causing this?

See answers to this question

Discuss this question

Mr maria baker
What are the two types of compression joints?

There are no answers to this question

Discuss this question

cat mac
hi my bolier is broken, the oil is getting to it but the jet is going out aftre 5 sec.

There are no answers to this question

Discuss this question

cat mac
My boiler is broken, it is a Danfuss boiler, it is getting the oil okay except the jets are cutting off after 5 secs.

There are no answers to this question

Discuss this question

Mr michael conneely
My shower valve is not letting hot water through is this due to water scale or does it need replacing?

See answers to this question

Discuss this question

Mrs  Richardson
Where would I put the condensing pipe from my boiler as I live in a third floor flat?

See answers to this question

Discuss this question

Pat
I have a Polyphosphate Scale Inhibitor on a new central heating system. I have an old polarity inhibitor, can I add this to my system as well or will the electronic inhibitor have a negative effect with the other system in place?

See answers to this question

Discuss this question

Pat
Can I mix descaling inhibitors?

See answers to this question

Discuss this question

krusty1958
Bath was filling OK then slowed to a trickle water in cold tank that feeds hot water.

There are no answers to this question

Discuss this question

Mr Steen Jones
Can I have a indirect cylinder in the same room as a OIL boiler?

See answers to this question

Discuss this question

alansin
In Plumbing what is negative head pressure and positive head pressure?

See answers to this question

Discuss this question

mario
I have a combi boiler and had to shut off the water to change a tap. When I turned the water back on I had no hot water, It must be air lock. How do I get this away?

There are no answers to this question

Discuss this question

Mr mark williams
Anyone know anything about Baxi 105HE combi boilers?

I have an intermittent fault the hot water and the heating works OK, but when the heating is on and a hot tap turned on, it will heat the hot water and when it goes back into central heating mode it locks out..

any ideas

thanks

There are no answers to this question

Discuss this question

Mr James Hurney
Smelly sewer in basement?

See answers to this question

Discuss this question

Mrs Phyllis McGonigle
Why is my hot water just trickling out of the taps?

See answers to this question

Discuss this question

Mr glenn Thornton
What is the minimum operable window size for a room with only a w.c?

There are no answers to this question

Discuss this question

lostlibertine
On a electric shower, why is water only coming through the overflow?

There are no answers to this question

Discuss this question

Mr glenn Thornton
In a row of five houses with a combination of ventilating pipes and air admittance valves, where must a ventilating pipe be situated?

See answers to this question

Discuss this question

Mr glenn Thornton
What is the minimum radius for the bend at the foot of a soil stack?

See answers to this question

Discuss this question

Mrs jean drysdale
When the toilet is flushing it sounds like an aeroplane taking off?

See answers to this question

Discuss this question

sandra
Petrol smell in en-suite bathroom?

There are no answers to this question

Discuss this question

Mr lee grinyer
Can you plumb in a towel rail from the top, ie flow and return?

See answers to this question

Discuss this question