Mr JOHN NICHOLSON
I have a 1999 Chevy Silverado that wont start. The fuel pump is running bit it seems to not be firing. It has electronic ignition??

There are no answers to this question

Discuss this question

Ms ronnie lucero
Does used auto dealership have to disclose that a vehicle you are about to purchase has been wrecked before and repaired?

There are no answers to this question

Discuss this question

Miss angela powers
My truck will not fire.. tested the electrical parts and replaced coil, & truck is getting gas, tested alternator, battery, and starter and they are good, also replaced plug wires... what else can it be?

There are no answers to this question

Discuss this question

Mr tony coley
I need how to replace intake manifold gasket on a 1996 Chevy pickup k-1500. motor size 510?

There are no answers to this question

Discuss this question

Mr Lee Schroeder
Why does my gas pedal stick drastically when I slow down from freeway speed? So much that I cannot push it down to give it gas. It feels like it wants to stall. I drive an 01 Chevy Tahoe and recently had the fuel pump and fuel filter both replaced.

See answers to this question

Discuss this question

Mr Dion Lepine
How to change the tail shart bushing in a s10 auto transmission?

There are no answers to this question

Discuss this question

Mr chris rimmer
I have a 1972 ford f-100 302 engine with a 3 speed. I want to install a 5 speed out of 1980's or early 1990's mustang. Can this be done without any drastic modification?

There are no answers to this question

Discuss this question

squaddie elite
What torque setting do I use?

There are no answers to this question

Discuss this question

ryp
How do I remove the passenger seat in my 1993 Toyota pick-up truck?

There are no answers to this question

Discuss this question

Mrs Sof rob
How to change CV joint on 4 wheel drive Toyota?

See answers to this question

Discuss this question

 Nick Wolff
I have a 95 Nissan truck, when the key is in the accessories position my fuel pump starts running, the truck will attempt to start but wont turn over, is this a problem with my relay, please help?

See answers to this question

Discuss this question

Mr Lee Gonzales
Where is the blower motor resister on a 1991 Toyota 4wd p/u 3.0L fi engine?

There are no answers to this question

Discuss this question

Ms denise haggard
Need to know about wiring sys for 1980 Toyota 4x4 truck?

There are no answers to this question

Discuss this question

Reverend anna boscacci
1999 Chevrolet silverado-do I use straight coolant in it or a 50/50 mixture or 50/70? I don't want to destroy my truck.

See answers to this question

Discuss this question

bubbamaster
How do I remove the indash cupholder on my 1999 Dodge Ram? I got the 4 screws out and it wont come.

See answers to this question

Discuss this question

AKA Customs
I am running out of ideas on what is wrong with my K 3500. The truck is overheating and I can't figure out why. I have changed recently the starter, alternator and tensioner system. It has a new belt, which I have rechecked to make sure it is routed properly. The last oil change was done at the time it was overheating, and the oil pan was dropped at this time, I had no water/antifreeze in it so I don't believe it is a head leak. All the hoses are new and are not cracked so I am not leaking there. And I have just put in a new performance thermostat. I am running out of options and I do not want to pull the engine and start from scratch. I wasn't planning on pulling the engine for at least one more year. Any help on why I am overheating? It has me stumped. Thanks.

See answers to this question

Discuss this question

AKA Customs
I have an 89 K 3500, which recently has had a few problems. I had starting and power problems. After taking off the starter which was fine I found that my main power line was pinched at the block. I replaced the power wire and a new ground wire off of an optima red-top. I then replaced the serpentine belt that was starting to show signs of wear and the alternator which had a frozen bearing, and a tensioner that had a small crack in the casting. Now I have an overheating issue, and don't know what is causing the fault. I started the truck set my rpms at 2000, popped the hood and just watched. There was no leaks in the radiator or any lines. The water pump seems to be working though I am not 100% positive. However after about 15 minutes it started boiling over and coming out of the overflow tank. Is this a thermostat issue or something else? Thank you for your help.

See answers to this question

Discuss this question

Sir Pausley Greens
I need a carburetor for a 78 Toyota pickup if someone has one please get ahold of me asap ....

my name is pausley

There are no answers to this question

Discuss this question

hati
EBS systems are now been fitted to some LGVs. What does EBS stand for?

See answers to this question

Discuss this question

jimboni
I recently purchased a Chevy 1961 Apache Fleetside pickup and I'm restoring it including all new electrical harnesses. After installing it, the truck won't start. It cranks, but doesn't have spark. Also, I'm not getting lights or accessories. What is the problem?

See answers to this question

Discuss this question

Sir Pausley Greens
Hi I have a 1978 Toyota pickup and I just rebuilt the carburetor it helped it run a lot better but now it is starting to backfire and spit flames out the tailpipe I was told it could be the distributor or one of the censors is bad I was wondering if anyone knows about it? thanks pausley G.

See answers to this question

Discuss this question

Double D
I have a 1996 Chevy Tahoe Suburban that keeps overheating even though new water pump, thermo, installed no visible blocks in hoses water pours from behind motor on bottom before pumpkin what is wrong?

See answers to this question

Discuss this question

Dale
The breaks are very touchy like if you push them in more then about an inch or so they lock up and the truck bucks till it stops.

See answers to this question

Discuss this question

Ms Patrice V
How do I get my brake tester rollers gritted with the same grit as vosa?

There are no answers to this question

Discuss this question

Mr Ron Van Vliet
I have a 77 f-150 4x4. When I'm putting my boat in the water, or backing down a hill I can push on my brakes as hard as I can and the truck still wants to roll. Brake pads are good, new master cylinder. Brake pedal is not spongy. traveling down a highway I can hit the brakes as hard as I can, but can't get them to lock up.

See answers to this question

Discuss this question

Mr robert callahan
96 jeep Cher. Laredo at 40 to 50 mph the steering wheel and whole vehicle shake uncontrollably and dont stop till I slow down. I tried driving in pt 4wdrv and it worked for two days but now is shakin again. It has 215,000 and has been well maintained, I do know that IT IS OVERDUE FOR TIRES ETC.

There are no answers to this question

Discuss this question

trshytrucker
I have a 95 f-250 pu.truck has loss of power, starts to heat up more than normal and has a clicking sound coming from motor. Also has a slight blowby and hard to start after being drove 4 30 min. If you let it sit for a few min it will start up again.

There are no answers to this question

Discuss this question

Mr Darren Pettibone
The front bumper on my 05 Chevy silverado was pushed in about 2.5 inches on the passenger side after a small collision with a dumpster. Is this something that can be fixed simply by realigning the bumper or would there be mount damage etc?? the bumper has no visible damage to it other than the alignment issue. Any help would be greatly appreciated.

Thank you

There are no answers to this question

Discuss this question

Mr mike cosgrove
Does anyone here have experience with 1934 ford trucks- not pickups but the bigger ones like stakebeds with dual rear wheels? thank you

There are no answers to this question

Discuss this question

Mr David Kingman
Why don't truck manufacturers offer diesel on a half ton pickup ?

See answers to this question

Discuss this question